Jump to content
Matt Collier

atc-discussion TLA (TALLA) SID - Edinburgh

Recommended Posts

Matt Collier

Hi all,

Just a reminder regarding the use of TLA (Talla) departures at Edinburgh. The SID is non-jet only, with the exception of aircraft routing via (U)L602 and Y96. For example, if a B738 files TLA N864 DCS, you should ask them to refile with the GOSAM departure. However, if a B738 files TLA UL602 OTR, this is acceptable as the airway UL602 is included in the route.

If anyone has any questions, please don't hesitate to contact me.

Thanks,

Matt

Share this post


Link to post
Share on other sites
Guest
This topic is now closed to further replies.

  • Similar Content

    • Sebastian Wheeler
      By Sebastian Wheeler
      Just a slight query related to the above:
      I was fortunate enough to partake in a weeks worth of work experience with NATS recently, and while at whitely on the ADC sims, I heard the following phraseology being used "G-ABCD, Cleared to enter controlled airspace via Route A, at or below altitude 2000 feet, QNH 1014."
      Upon asking one of the pseudo-pilots about the change, I was told it is "new phraseology" can anyone else confirm whether this is the case? Apparently, it was put in place after some confusion from pilots after receiving a "not above" clearance.
    • Steve Riley
      By Steve Riley
      Just reading the new sid charts , am I right in saying hand offs are going to LONDON or SCOTTISH  and not radar as no mention of Radar on the charts.
      2. After departure, aircraft shall remain on the Tower frequency until instructed. 3. En-route cruising levels will be issued after take-off by 'London Control'. 4. Report callsign, SID designator, current altitude and cleared level on first contact with 'London Control'.
      I have not got the old charts to confirm this as I take them straight from NATS web site. 
      Also frequencies have changed are we changing them within ES ?
        123.980, 131.005  BIRMINGHAM APPROACH/RADAR
        118.305  BIRMINGHAM TOWER
      121.805  BIRMINGHAM GROUND 
       

       
       
    • Thomas Wowk
      By Thomas Wowk
      As above, how do you guys assess the runway surface condition on VATSIM? Do you make a visual assessment from the visual control room in correlation to the current/prevailing weather conditions or do you assess this purely off the METAR/TAF?
       
      The only reason i ask it that the surface condition of a runway really affects our landing performance (each operators SOP's may be different for the same aircraft type) Specifically if the runway is declared as DRY full length our crosswind limitations may be increased, whereas if the runway is declared WET full length, crosswind limitations are decreased. If i also needed to return after departure due to an emergency and perform an overweight landing, a DRY/WET surface also makes quite a difference for our overall LDA requirements. 
       
      Cheers
    • Thomas Wowk
      By Thomas Wowk
      Hi all,
       
      For the ones who enjoy carrying out IFR circuits in large aircraft, Doncaster Sheffield (EGCN) accepts visual circuits for aircraft above 5,700kg - B737/B757/B767/B747 etc. 
       
      The circuit profile & procedure can be found in the textual data in the AIP for EGCN. Primarily speaking only one aircraft can be in the circuit at a time. Be nice to get TWR on at EGCN from time to time to accept more training traffic within the network.
       
      The circuit profile briefly summarised as below:
       
      Visual circuits by aircraft above 5700 kg must comply with the following noise abatement procedures.
       
      i. Runway 02 After departure turn right crosswind at no greater than 2.5 DME, fly downwind at 2000 FT QNH, report final south of Bawtry (3 DME) and not below 1500 FT QNH.
      ii. Runway 20 After departure climb on track 190°, at 1.5 DME turn left crosswind, fly downwind at 2000 FT QNH and report final not below 1500 FT QNH
       
      Cheers.
       
       
    • Chris Pawley
      By Chris Pawley
      The Letter of Agreement between London and Amsterdam (Dutch vACC) is revised to take into account changes in AD3 at the end of 2018. It's available here.
       
      Chris.
×
×
  • Create New...